Manufacturer: Seagate | Model: ST34501W | TD# 270262 |
Interface... UltraSCSI | Formatted Capacity... 4,550 MB |
Cylinders | 6526 | Heads | 8 | Sectors | Variable |
Landing Zone | Cyl + 1 | Precomp | N/A | RWC Cyl | N/A |
Encoding Method | PRML | Xfer/Mb | 40 | MTBF (Hr X 1000) | 1000 |
Form factor | 3.5" | Novell Y/N | Y | Height | 1" |
Power (Typical) | 6.74W | Power (Max) | 11.1W | Speed (rpm) | 10,000 |
Avg seek (ms) | 8 | Cache | 512k | Mfg. Warranty | 5 YRS |
NOTE: Can also be operated according to
SCSI-1, SCSI-2, and SCSI-3 protocols.
Copyright ⌐ 1996, 1997 Tech Data
Corporation
Configuration and Jumper Options
If your system is "SCAM" (SCSI Configured Auto
Magically) compliant, the system assigns the drive ID over the
interface, so there is no need to be concerned about drive ID.
Setting the drive ID jumpers doesn’t hurt anything, but is
not necessary.
If your system is not "SCAM" compliant you do need to
set the drive ID using the ID jumpers. Optional connections to
switching circuits in host equipment are provided on J1 auxillary
to set the SCSI ID. (See Below)
The ST34501W drives are terminated with permanently mounted IC active terminators. If you install one of these drives and it is not on the end of the SCSI bus, disable the terminators by removing the jumper from pins 15 and 16 of connector J2 (see below). If you install the drive on the end of the SCSI bus, enable termination by installing a jumper on pins 15 and 16 of connector J2.
There are three possible terminator power configurations for the ST34501W drive. You will not normally need to change this option and can leave the drive configured as it was from the factory.
The default is parity check of the SCSI bus enabled. To disable this feature, install a jumper across pins 7-8 on J2.
Enable motor start. The drive waits for the Start Unit command from the host before starting the motor. Jumper across pins 11-12 on J2. Disable motor start (default) The drive starts according to the delay motor start option setting as described below.
Enable motor start delay. Motor start delay is equal to the SCSI ID X 12 seconds. Install a jumper across pins 13-14 on J2. Disable motor start (default). Remove jumper from pins 13-14 on J2.
Write Protect = On (disables writing) Jumper across pins 9-10 on J2. Write Protect = Off (default) no jumper.
[Main
Menu] [Hard
Drives] [Controllers] [Tape Drives] [Glossary]